[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 583: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 639: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4516: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3262)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4516: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3262)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4516: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3262)
rs246 • RS4 B7 Lambdasonde
Seite 1 von 1

RS4 B7 Lambdasonde

Verfasst: Montag 23. Juli 2018, 19:27
von Klinge
Hallo zusammen.
Ich habe meine beiden vorderen Lambdasonden getauscht, weil ich einen Fehler hatte. Nachdem beide neu waren, kam der Fehler wieder und mir wurde vom netten von nebenan gesagt, dass defintiv die vordere linke Lambda defekt ist. Ich hatte noch Garantie drauf, also die linke nochmal neu gemacht, weils so schön ist und zack, nach ca. 60km fahren kommt:

Fehler P2234 - Lambdasonde 1 Zylinderreihe 2 Signalstromkreis gegen Heizstromkreis kurzgeschlossen
und
Fehler 2231 - Lambdasonde 1 Zylinderreihe 1 Signalstromkreis gegen Heizstromkreis kurzgeschlossen.

Der Kabelbaum ist soweit i.O. und die Lambdasonden sind richtig angeschlossen.
Jemand einen Tipp, was ich noch prüfen kann?

Danke vorab

Re: RS4 B7 Lambdasonde

Verfasst: Samstag 11. August 2018, 17:42
von Klinge
Niemand eine Idee?????

Re: RS4 B7 Lambdasonde

Verfasst: Sonntag 12. August 2018, 08:44
von treffisried
Steht ja dran. Kurzschluss zwischen Signalleitung und Heizstromkreis. Ist die Verkabelung wirklich in Ordnung?
Falls ja und du Bosch oder orignale Lambdasonden verbaut hast, bleibt ja nur noch das Motorsteuergerät.

Re: RS4 B7 Lambdasonde

Verfasst: Donnerstag 16. August 2018, 22:07
von Klinge
Hi, ja sind die originalen und der Kabelbaum ist ok. Motorsteuergerät... Kann ich das irgendwie prüfen?